AOR AR8200 Spezifikationen PDF herunterladen (Seite 71)

as a short cut to ALL (which is the default) which will cause all receive modes to be

scanned in the specified scan group. Use the main dial or ï ð keys to select the receive mode:

ALL, WFM, NFM, SFM, WAM, AM, NAM, USB, LSB, CW.

to accept the changes and return to the display

prior to accessing the scan environment menu. The ò key loops

back to the top of the SCAN-GROUP menu.

While scanning, only memory channels with the corresponding

receive mode will be scanned. The legend “SCAN NFM” or

“SCAN AM” etc will be displayed indicating that only specific

modes will be scanned, the modes are displayed in REVERSE

CONTRAST highlighting. If no channel contained within the bank

group matches the specified receive mode, the scan will be

aborted and the display will return to 2VFO mode with an error

beep sounding (if the beep is enabled).

7-8-6 Write protect of memory channels & banks

It is possible to write protect memory channels, whole memory banks, search banks and ‘globally protect’

memory to prevent data being accidentally over-written. Refer to

section 11

of this manual regarding the

write protect options.

7-9 Select scan

Select scan enables you to ‘tag’ memory channels to make a temporary list of up to 100 channels for

scanning in a separate list called the SELECT SCAN LIST. Memory channels from any of the 20

memory banks may be mixed together in any order and added to the select scan list.

7-9-1 Adding select scan channels in memory read

In memory read mode or when paused on an active channel in scan mode use the key sequence

to toggle the select scan tag on/off, the legend “SEL” confirms selection.

Even memories marked as channel pass may be added to the select scan list, the pass status will be

ignored by select scan.

7-9-2 Starting / stopping select scan

To start select scan you must first have at least two memory

channels tagged for select scan.

to start select scan. The legend “SEL” will be displayed on the left

hand side of the LCD to indicate that select scan is in progress.

The memory channels will be displayed as select scan progresses

and each memory channel will display the legend “SEL”. The

direction of scan can be reversed using the main dial or ñ ò keys.

To stop select scan, or or

Section 7-8-5, 7-8-6, 7-9, 7-9-1, 7-9-2

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 141 142

Keine Kommentare

AOR AR8200 Spezifikationen Seite 71