AOR AR8200 Spezifikationen PDF herunterladen (Seite 7)

more efficient means of monitoring the most wanted frequencies as you have targeted 100% what

you most want to hear, by contrast searching is very inefficient for day-to-day monitoring.

&Note:

It is very important that the squelch is advanced to cancel background noise for the

search & scan facilities to operate.

This is because the AR8200 believes that it has found an

active frequency when the squelch opens and “S” ‘squelch open’ legend is displayed to the left

of the signal meter. Advance the squelch control clockwise until the background noise is just

cancelled, this is known as the threshold position. If the squelch control is advanced too far,

weaker signals may be missed.

No noise and no “S” legend (with squelch advanced clockwise passed

threshold) = squelch closed.

Signal received or ‘noise’ emanating from speaker (squelch fully anti-clockwise, below

threshold) with no “S” legend = squelch open.

1-4 Accessories supplied

The following items are provided in the carton box:

1 x AR8200 receiver

1 x Whip aerial in BNC connector

1 x Medium Wave (MW) bar aerial

4 x AA NiCad batteries

1 x Charger (may be supplied in a separate cartons in some world market areas)

1 x Cigar adapter lead (containing internal 1A fuse)

1 x Hand strap

1 x Belt hook with two screws

1 x Operating manual (this booklet)

How to fit the hand strap

The hand strap anchor is located on the right hand side of the

AR8200 cabinet. The hand strap comprises of two loops, one

large and one small. Feed the small loop through the anchor

then feed the large loop through the small loop and gently pull

until tight. This strap is designed to be looped over your wrist

to prevent the AR8200 from contacting the ground if

accidentally dropped, it is not intended as a hard wearing

utility… do not swing the set or abuse the set using this

hand strap.

The MW bar also has a fixing hole so that you may tie it

down to prevent loss.

How to fit the belt hook

The belt hook is a shaped metal plate with two fixing holes on the top

edge, two fixing screws are provided. Do not use any other screws…

if you attempt to use longer screws, the internal parts may be permanently

damaged rendering the AR8200 inoperative. Offer the belt hook to the rear

of the AR8200, locate and align the fixing holes then carefully fit the two

supplied screws, fit both screws before tightening with a cross-head

screwdriver.

Section 1-3, 1-4

1 2 3 4 5 6 7 8 9 10 11 12 ... 141 142

Kommentare zu diesen Handbüchern

Keine Kommentare

AOR AR8200 Spezifikationen Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger AOR AR8200