AOR AR8200 Spezifikationen PDF herunterladen (Seite 136)

136

It is possible to load a band scope directly from EM8200 external memory for immediate display on

the LCD. Use the key sequence to access the band scope load

menu, the legend “B-SCOPE LOAD” will be displayed.

the key to toggle the memory selection between INTERNAL “INT” and EXTERNAL

“EXT”, the default is “EXT”. Select “EXT” then use the main dial or ï ð keys to select one of the

EM8200 memory locations (0, 1, 2 or 3). to recall the trace directly to the LCD for

immediate viewing.

&Note: For further information regarding the band scope, please refer to

section 15

of this

manual.

(19) Trouble shooting

Should the AR8200 appear to act strangely, check out the following suggestions to see if the problem

can be overcome. Failing this, switch off the AR8200, disconnect any external power connection and

remove one battery from the radio (if you have batteries fitted). Wait for at least 30 seconds then re-fit

the battery (if in use) or re-connect the external power and switch the radio on again with a of

the key.

Check to see if the problem has cleared.

19-1 Soft reset of microprocessor

If removing power and switching the AR8200 off / on does not help, try a soft reset of the microprocessor.

Soft reset is achieved by powering-up the radio with the key held, do not release the

key until the opening message has performed and a frequency is displayed in 2VFO mode.

All scan & search environments are cleared, bank link is set off and the receiver frequency will be set to

88.000 MHz for both VFO-A and VFO-B. The beep will be enabled and set to default as will lamp and

LCD contrast. All memory and search bank data will be intact.

19-2 Other trouble shooting suggestions

AR8200 will not power on. Check that the set is connected to external power (12V d.c.) or that

batteries are fitted and are fully charged.

There is no audio. It may simply be that the squelch is closed or volume is turned down. and

hold the key and adjust the volume to a comfortable level. Ensure that no external loudspeaker,

headphone or earphone is in use. Check that the band scope is not in operation.

AR8200 display is strange and there is no audio. Check that the band scope is not in operation,

Section 19, 19-1, 19-2

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 142

Keine Kommentare

AOR AR8200 Spezifikationen Seite 136