AOR AR2000 Bedienungsanleitung PDF herunterladen (Seite 41)

AR1000 Applications

Copying a group of frequencies

Because the AR1000 memory space is so large, you may periodically want to

rearrange where you keep sets of frequencies. Instead of referring to your bank/

channel records and manually entering in the group of frequencies you want to

move, use this method to copy a group of frequencies from within the scanner.

This method will be less tedious than manually re-keying them in and you will

have less chance of making mistakes and entering incorrect frequencies.

The procedure is simple. Press BANK, then specify your source channel, then

press PROG, and a destination channel for each channel you want to copy.

• Press BANK and the first channel number of the group you want to move.

For example, to move channels 110 through 120 to channels 830 through 840,

press BANK 110.

• Press PROG and the first channel of the destination group.

In the above example, press PROG 830.

• Repeat the first two steps, incrementing the source and destination

channels by one each time.

The first four copies would be done with this sequence:

BANK 110 PROG 830

BANK 111 PROG 831

BANK 112 PROG 832

BANK 113 PROG 833

You have to remember to increment both the source channels and the destina-

tion channels. With this method, the channels need not be sequential channels,

but this operation is much simpler and easier to perform if they are sequential.

When you copy a frequency from a channel into a new channel, both the fre-

quency and the mode are copied automatically. In addition, if the channel is

locked, the locked status is also copied into the new channel. This method will

even allow you to copy channels from one locked bank to another locked bank.

After you copy a group of channels from one area of your scanner memory to

another, you will have two identical sets of frequencies. The chances are that you

only want to use the frequencies in the new location. In this case you need to go

back to the original group and “mark” the channels as available (see page 19).

This is preferable to simply locking the channels, because it will remind you that

the space is available for new frequencies. You can lock a channel at the same

time as you mark it to keep the marked channels from being scanned.

To copy a

group of

frequencies

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 90 91

Keine Kommentare

AOR AR2000 Bedienungsanleitung Seite 41