AOR AR2700 Bedienungsanleitung PDF herunterladen (Seite 3)

- 3 -

The [PROGRAM] socket is the primary receiver connection used for computer control. This port also takes

power from the receiver (when the AR2700 is switched On).

Should you wish to CLONE data between two AR2700 receivers, connect the second ribbon cable to the

socket labelled [COPY].

2. Remove the battery compartment lid of the AR2700 using a downward sliding motion.

Locate the remote control socket which is located at the bottom edge of the battery compartment.

Insert the ribbon cable (with the reinforced plate) contact (metal) side facing toward the front of the

receiver and the blue tab facing you (so that the cable is not twisted)

IMPORTANT

If the receiver has a four pin remote socket the optional IF-ADP cable will be required... in which case please

contact your dealer.

It may be difficult to insert the flat cable into the CU8232 or AR2700 socket for the first time as they are

necessarily quite tight. If this is the case, try inserting with a little upward pressure, it should become easier

the next time.

DO NOT APPLY EXCESSIVE STRESS TO THE FLAT CABLE UNDER ANY CIRCUMSTANCES.

A DC voltage is fed to the CU8232 by the AR2700 connected to the [PROGRAM] socket. When the receiver

is switched On, the AR2700 DATA is routed to the RS232 connector.

If a second receiver is connected to the [COPY] socket and switched On, the CU8232 recognises it’s

presence and routes data between receivers and not to the RS232 socket.

3. To CLONE data between two AR2700 receivers, connect each receiver to the CU8232 using a ribbon

cable as outlined above. Data may be transferred in BOTH direction between the [PROGRAM] and

[COPY] sockets.

4. Switch both receivers On and run the CLONE functions as detailed on page 57 section 15 of the

AR2700 English language operating manual.

Caution!

Make sure that no low / flat batteries occur while the data clone is in progress. Although no significant extra

current is required for clone operations, flat batteries may cause corrupted data transfer. It is advisable that

the receivers are both powered from their chargers (which were supplied with the receivers) during clone

operation.

5. If a data clone fails retry the procedures of clone operation after checking the following:

¶ Make sure that all connections are correct and there is no loose contact.

¶ Ensure that one receiver is in TRANSMIT mode and the other is in RECEIVE mode.

¶ Always press the [ENT] key of the AR2700 in RECEIVE mode first so that it is ready to accept data.

¶ Press the [CLEAR] key of the receiver prior to the retry if the failure is due to incorrect connections

or an error in key sequence.

6. An alternative method may be used to connect two AR8000 receivers for data CLONE. Two CU8232

interfaces may be employed with each AR2700 connected to the [PROGRAM] socket. The RS232

9-pin connectors are linked using a three wire crossed cable:

CU8232 CU8232

Pin 2 Pin 3

Pin 3 Pin 2

Pin 5 Pin 5

No other pins are used.

Connection & clone

1 2 3 4 5 6 7 8 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

AOR AR2700 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger AOR AR2700