AOR SDU-5000 Bedienerhandbuch PDF herunterladen (Seite 15)

In the Spectrum Analyzer mode, the receive frequency is equal to the center frequency

of the screen.

In the Spectrum Analyzer mode or the Step Resolution mode, the center frequency

can be changed by numeric keypad.

You may also change the center frequency by the Center Frequency key that is defined

at the center of the Special function keys. In this case, the receive frequency will

change according to the step displayed on the top right of the screen of the SDU5600.

(Note: The center frequency cannot be changed if Other (10M) or Other (45M) are

selected.)

(Caution: Once frequencies are entered using the numeric keypad, the main tuning dial

will be temporary disabled. To use the rotary dial encoder again, press the [CLR]

key and the press the [CENTER FREQ.] key of the Special function keys.)

Memo: Center frequency vs. Tuning frequency step

Using the rotary dial encoder of the SDU5600 will change the frequency with the step

set by the one indicated at the top right of the screen.

Using the rotary dial encoder of the AR5000 receiver will change the frequency

with the step set by the receiver.

6-4-2 Channel Scope Mode

In the Channel Scope Mode, the receive frequency is indicated by a yellow

triangle on the screen, which is referred as the Receive Marker.

(Note: There is another marker on the screen. This is a marker that you can move

freely on the screen to check the frequency.)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 38 39

Keine Kommentare

AOR SDU-5000 Bedienerhandbuch Seite 15