AOR AR8000 Bedienungsanleitung PDF herunterladen (Seite 12)

- 12 -

¶ For further information regarding WINDOWS TERMINAL and configuration,

please refer to the operating manual supplied with Microsoft software and

the computer.

Click on “COMMUNICATIONS” then select the options as shown in figure 11.

The choice of COM port (COM1, COM2 etc) will depend upon your computer

serial port and mouse configuration. Finally click on [OK].

(7) How to send a command

Each command comprises of two upper case letters (header) along with options

as required. All commands use ASCII code which MUST BE IN UPPER CASE

(except for the “ARROW” é ê which uses the control code of ASCII).

A multiple command entry is only valid where specified. Where a multiple

command entry is allowed, each command MUST be separated with a space

“h20” (HEX DECIMAL).

Each command is completed with a [CR] or [CR],[LF] whichever is specified in the

AR8000 receiver configuration (page 101 section 18-1 of the English language

AR8000 operating manual), thereafter described as [ï].

Although there is no local echo, either [ï] or a specified response should come

back from the receiver after confirming the correct command.

A space is often shown as "_" in the following examples.

REMOTE indication

When the AR8000 has received a command via the RS232C port the receiver’s

LCD with alternate between the top line of data and the wired “REMOTE”. When

remote mode is engaged the receiver’s keypad becomes inoperative. To restore

operation to the receiver’s keypad press [LOCAL] - effectively remote operation is

cancelled. Remote mode is re-engaged when a new command is received via the

RS232C port.

The receiver always acknowledges the receipt of a command by sending [ï]

(as specified in the receiver configuration) or will respond with the requested data.

Only send a second command after the first command has gained a response.

If no response has been gained after a short while, the receiver has failed to

receive the command properly. Send a [ï] then re-send the command. Should

problems persist, check your serial / CU8232 connections and try reducing the

RS232 baud rate.

Sending a command

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Keine Kommentare

AOR AR8000 Bedienungsanleitung Seite 12