AOR AR8000 Bedienungsanleitung PDF herunterladen (Seite 3)

Power up:

When the Scout is twitched on, a display self test is performed. The self-test

consists of illuminating all front panel display segments and annunciators for approximately

two seconds, followed by displaying 'SCOUT' for another two seconds and then the

communications LANGUAGE enabled for another two seconds. The Scout then begins

operation in the operating mode selected by the FILTER and CAPTURE switches (AOR

AR8000 or CI-V ICOM).

Changing the position of the CAPTURE switch during the display self text will toggle the

serial communications language between CI-V and AR8000. The default communications is

9600bps, experiment with CR/LF or place the AR8000 into NEW_USER_MODE, the

parameters will then be correct! Place the AR8000 in 2VFO mode, remember, reaction-tune

will only occur when active new frequencies are clocked by the Scout. When new

transmissions are encountered, the AR8000 will react and follow the display of the Scout

immediately, after a period of monitoring recall the SCOUT MEMORIES to select which

frequencies you wish to store into the AR8000.

AR8000 Keypad Replacement

The AR8000 keypad comprises of a complete membrane with carbon printed contacts.

Eventually with use, the carbon will deplete resulting in failure. There were two types of

replacement keypad as spare parts, standard (original) and 'hard shell' (later)... the 'hard'

type has a cover over the printed letters to prevent them from wearing off.

A new keypad has been introduced in 2003 to replace BOTH types of keypad. The part

number is:

Standard

A few customers have commented on slight difficulty when fitting the later types of keypad

on earlier sets and feel that the later keypad may be very slightly larger (the front case holes

of the later sets providing greater clearance) so have had to carefully enlarge the clearance

with glass-paper etc.

Before any work is carried out, place the set on a bench covered with a duster to prevent the

set being scratched.

1) Remove 2 x screws (silver coloured) in battery compartment.

2) Remove 2 x screws on side panels. These are the small black screws located next to the

rubber side pieces. On each side, remove only the screw located nearest to the rear panel.

3) The front panel complete with the rubber side pieces can now be removed. To do this,

slight force is needed pulling the two case halves away from each other. Do not lever the

halves apart and do not twist them apart as inside connector pins may be bent.

4) With the front case half removed, the main circuit board now has to be removed from it in

order to expose the keypad.

1 2 3 4 5 6 7 8 ... 17 18

Keine Kommentare

AOR AR8000 Bedienungsanleitung Seite 3